New

How do I display my router routing table?

Use the show ip route EXEC command to display the current state of the routing table….Sample Displays.

Field Description
Routing entry for 131.119.0.0 (mask 255.255.0.0) Network number and mask.
Known via “igrp 109” Indicates how the route was derived.

How do I access my RT-AC66U router?

Router Model: RT-AC66U

  1. Username: admin.
  2. Password: admin.
  3. IP Address: 192.168.1.1 Login.
  4. SSID: ASUS.

How do I add a route to my Asus router?

Static Route Configuration on ASUS Routers

  1. Open a web browser and enter your routers IP Address into the address bar in order to access the network settings page.
  2. Confirm your routers IP Address by selecting “General” -> “Network Map” from the navigation menu on the left side of the screen.

How do I find my network routing?

Follow these steps to run a network path trace:

  1. Open the Start menu and select Run.
  2. Type cmd and select OK.
  3. This will open the command prompt.
  4. You should see the traffic path taken to your site.
  5. Don’t worry about understanding the output.
  6. Paste the output to an email and send it to the appropriate support personnel.

How do I find my IP routing?

Use the Netstat ROUTE/-r command to display routes to the network. Verify whether TCP/IP has a route to the destination. For information about the Netstat ROUTE/-r command, see z/OS Communications Server: IP System Administrator’s Commands. If there is no route, proceed to step 3.

How do I access my Asus router admin page?

1. Enter your router’s IP address in the browser of your device. If you cannot find the IP address, type: http://router.asus.com in your browser for ASUS router models, or http://repeater.asus.com for ASUS range extender models.

How do I reset my RT-AC66U router?

To reset the ASUS RT-AC66U to its default settings, you have to do the following steps:

  1. Put router into operation.
  2. Press Reset button and hold for at least 5 seconds.
  3. Restart of the device is automatically executed.
  4. Router has been reset to factory settings.

How do I setup a LAN route?

Go to LAN>>Static Route, select index 1 and tick Enable. b. Enter the following below: Destination IP address = 192.168….4. Configure Static Routes.

  1. Destination IP address = 192.168. 10.0.
  2. Subnet Mask = 255.255. 255.0.
  3. Gateway IP address = 192.168. 2.2.
  4. Network Interface = LAN2.