How do I access my WRT54G?

Open a web browser and enter http://192.168.1.1/ as the URL, and admin as the password. Change the default router password from admin to something more secure. Be sure to take note of the password. Store the password in a free password manager.

What is the default IP address password?

The default IP address is 192.168. 0.1. At the login, enter the username (admin) and your password (default password is nothing). Note: If you have forgotten this password, you will have no choice but to reset the router to factory defaults.

How do I find my Linksys router password?

Checking the Linksys Wi-Fi Router’s name and Password

  1. Launch Linksys Connect on the computer that was used to set up the Linksys Wi-Fi Router.
  2. On the Linksys Connect main screen, select Router settings.
  3. The Router name and Password are found under the Personalize section.
  4. Launch a web browser like Internet Explorer.

Can’t reset password on WRT54G?

Re: Can’t reset password on WRT54G 1) Power down all computers, the router, and the modem, and unplug them from the wall. 2) Disconnect all wires from the router. 3) Power up the router and allow it to fully boot (1-2 minutes). 4) Press and hold the reset button for 30 seconds, then release it, then

What is default password for Linksys WRT54GL routers?

Power – The Power LED flashes green when booting up.

  • DMZ – Lights up green when Demilitarized Zone (DMZ) is enabled.
  • WLAN – The Wireless LED lights up green when there is a wireless connection.
  • Ethernet (1,2,3,4) – The Ethernet LED lights up green when there is a wired connection.
  • How to reset Linksys WRT54G?

    Access the router’s web-based setup page.

  • When the router’s web-based setup page opens,click Status then click Wireless.
  • Take note of the MAC Address.
  • Connect a computer to the access point.
  • Assign a static IP address on the computer.
  • How to convert Linksys WRT54G to be an access point?

    Start with a wired PC. Document your current network’s IP address scheme.

  • On the back of the router,remove the “Run CD First” tape. Do not connect any cable to the “WAN” port
  • Disconnect the existing network cable from the network jack of your PC,set it aside for now.
  • Power the router.