How much does it cost to replace a wheel bearing on a Toyota?

What’s the cost for wheel bearing replacement on my Toyota. For a national average across all vehicles, the average cost to replace the wheel bearings (for 1 wheel) is about $350.

How much does it cost to replace both front wheel bearings?

Both Sides The cost to replace both front wheel bearings is going to be between $260 and $480. The parts alone for the front wheel bearings are about $120 to $200. However, the labor costs will be a bit more extensive at around $140 to $280.

How long do Toyota wheel bearings last?

about 85,000 to 100,000 miles
Although wheel bearings are engineered to last the entire lifespan of your vehicle, they can break and get worn out. Most wheel bearings last about 85,000 to 100,000 miles before they need to be replaced. Some vehicles have wheel bearings that last a lot longer, and some vehicles need them replaced fairly quickly.

When should a Toyota Tacoma wheel bearing be replaced?

Any bearing that is not factory sealed will need maintenance to keep it operating. Your Tacoma owner’s manual may give you a maintenance schedule for the bearings. If it does not, you should take them apart, clean and inspect them every 30,000 miles.

Do you need alignment after replacing wheel bearing?

Yes, you will need alignment if you unbolt the knuckle. If you separate the ball joint, remove the axle from the knuckle, you can press the bearing in/out with the right tool.

How long do Toyota Tacoma wheel bearings last?

100,000 miles
Sealed bearings can last 100,000 miles or more, and will need to be replaced once they go bad. Vehicles with traditional, tapered wheel bearings should have them serviced every 25,000 to 30,000 miles — replacement may not be necessary as long as they’re maintained.

How do you diagnose a bad wheel bearing on a Toyota Tacoma?

Jack up your Toyota Tacoma until the wheel can move freely. Then grab the wheel with both hands at the opposite sides and alternately press and pull. If the play is clearly noticeable and visible, then the wheel bearing is very likely defective.

What does it cost to replace front wheel bearings?

These bearings can easily be replaced, are less expensive to buy, and generally cost around $6-20.00 per unit, and $80-100.00 to service, along with the cost of replacing the rotor usually, as the bearing race is pressed in. All in, labor and rotor, most vehicles will run around $150.00 to replace and go up depending on rotor cost.

How to replace front wheel bearings without press?

Replacing wheel bearings can be time-consuming but is generally relatively straightforward, though it often requires special tools to do the job easily. The bearing race is the part that the bearings ride on and is pressed into the hub. One alternative method to pressing in a bearing race is to use a socket to tap it into place.

How to remove front wheel bearing?

Loosen the hub nut over the drive axle with a socket wrench.

  • Slide an automotive jack under the front of the car. Pump the handle to raise the jack and lift the car.
  • Unscrew the lug nuts with a socket wrench and pull the wheel off of the lug nut studs.
  • Remove the hub nut from the axle with a socket wrench.
  • How to replace a front wheel bearing in your car?

    Humming Noise. The most easily identifiable and common symptom of bad wheel bearings is audible.

  • Squealing,Growling. The typical sounds of worn-out wheel bearings are squealing and/or growling.
  • Clicking Sound.
  • Wheel Wobble.
  • ABS Failure.
  • Uneven Tire Wear.
  • Vehicle Pulls to One Side.
  • Steering Wheel Vibration.
  • Steering Feels Loose.