Lifehacks

How can I reset my Indesit washing machine?

Try to unplug the washer from the outlet for 2-3 minutes, then right after press and hold the start button for 3 seconds. This should reset the controls and allow you to put the washer into a drain/spin cycle.

What does F02 mean on Hotpoint washing machine?

F02 — Motor circuit fault. Issue: Intermittent or no drum rotation during wash cycle.

How do you read Hotpoint error codes?

Hotpoint And Indesit Washing Machine Error/Fault Codes

  1. F1 – Motor Triac Short.
  2. F2 – Motor jammed or tacho off.
  3. F3- NTC thermistor shorted or open circuit.
  4. F4 – Pressure switch jammed on empty.
  5. F5 – Pressure switch jammed on full.
  6. F6 – Not used.
  7. F7 – Heater relay stuck.
  8. F8 – Heater relay stuck.

Why does my Indesit washing machine keep beeping during a cycle?

Why is my Indesit washing machine beeping and flashing? The Indesit washing machine utilizes an acoustic signal to indicate the drum has finished its final spin cycle (or ‘drain’). This can be triggered by either pressing the button for “end” or waiting until it automatically stops.

What does fo2 mean on washer?

What does the error code F02 mean on Whirlpool washing machine front load washer? The F02 error code on a Whirlpool washer indicates that the control detects a long drain time. This can be caused by excessive suds in the tub, a restriction or clog in the drain system, or by a number of other component failures.

How do I reset my Hotpoint washer?

Motor Reset Procedure:

  1. Unplug the washer for 1 minute from the electrical outlet.
  2. Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
  3. The motor has now been reset and is ready for you to start a cycle.

How do I unlock my washing machine door?

Turning off the machine at the mains should allow the door lock to cool down, and after a few minutes, you’ll be able to open the washing machine door. The interlocks can take some time to release at the end of the cycle, so be patient. The most common cause is water left in the machine. Try running a spin/drain cycle.