How do you make a bong without plastic?

You can also put some aluminum on a pen cap to make a bowl for a homemade bottle pipe or bong. You can just make an aluminum foil bowl on top of any bottle or can and poke a hole at the bottom for a mouthpiece. Poke another hole on the side for a carb and smoke away.

How do you make a bong with a bottle and a pen?

Directions

  1. Create the downstem of your bong before you do something else with your water bottle.
  2. Unscrew the shaft and pop off the bottom bit with a butter knife.
  3. Remove the cap and empty your water bottle.
  4. When a small hole appears in the bottle due to the heat, quickly push the pen dowsteam through the hole.

What is the best bottle to make a bong out of?

Find a plastic water bottle; the standard 17-ounce size works best. If you can’t find a plastic water bottle, you can also use a soda bottle. Just be sure you take some extra time to clean the inside thoroughly — you don’t want all that sticky residue from the soda getting in the way of your smoking experience.

How do you make a homemade glass bong?

How to make a homemade bong step-by-step

  1. Step 1: Clean the glass bottle. Make sure the glass bottle is clean.
  2. Step 2: Prepare glass bottle for drilling.
  3. Step 3: Prepare drilling setup.
  4. Step 4: Start drilling!
  5. Step 5: Smooth and perfect glass bottle bong.
  6. Step 6: Insert grommet, downstem, and bowl.

How do you make a homemade gravity bong with a socket?

In case you were wondering, here is how to do it.

  1. Pick a suitable socket.
  2. Test the fit by placing the socket in the mouth of the bottle.
  3. Wrap duct tape around the sides of the socket to create a tight seal.
  4. Place fitted metal gauze into the socket to create a ‘bowl’ for your herb.
  5. Cut a hole in the bottom of the bottle.

How do you use a water bottle Bong?

Pack the bowl just like you would a normal bong. Pour water into the water bottle through the mouth, about a quarter of the way up from the bottom. Fire It Up! Place your mouth to the mouthpiece and your hand over the choke.

How to cut a gravity bong bottle?

To cut off the bottom of the bottle, carefully pierce it with a knife. Then, use scissors to cut around the bottle until the bottom is completely off. How much you cut off from the bottom doesn’t need to be precise. However, the more you cut off, the smaller the gravity bong hits will be.

Can You Make your own Bong at home?

Buying a new bong can be expensive. Fortunately, you can make your own bong at home using some cheap, basic supplies! With the right tools and a little bit of time on your hands, you’ll have a fully functioning bong in no time. Fill up a plastic bottle ¼ of the way with water.

Are water bottles better than soda bottles for bongs?

Water bottles are better than soda bottles because they won’t leave any sticky residue. You can remove the label from the bottle, if you want. You don’t have to leave any water in the bottle. However, if you want the bong to stand upright, you can leave some in to weigh it down.