Where is the heating element on a Frigidaire Affinity dryer?

The Frigidaire dryer heating element is on the inside of the back panel behind the dryer drum and is designed to provide the heat used to dry the clothes. The Frigidaire dryer heating element is set in a circular metal cage and can be replaced as a unit.

Why is my Frigidaire Affinity dryer not heating?

Blown Thermal Fuse The Frigidaire dryer thermal fuse location is in the back right corner of the dryer, attached to the heating element housing. Use a multimeter to check if the thermal fuse has continuity. If it is defective, replace it.

Where is the reset button on a Frigidaire Affinity dryer?

To reset a Frigidaire dryer, look to see if your dryer has a reset button on it that can be utilized. For most models, the reset button will be located on the control panel and once it has been found, simply press and release the button. Once released, the reset process will begin and complete.

What does e64 mean on a Frigidaire Affinity dryer?

If your Frigidaire dryer is displaying an e64 error code, it means the dryer is sensing there is a problem with the heating element. It could be that a coil has broken, the element has a short circuit, or a wire is defective.

How can you tell if a dryer heating element is bad?

Inspect the metal wire coil for any breaks in the wire. If the wire is solid and has no breaks in it, the heating element should be good. If the wire has a break in it, the heating element is defective.

How do I reset my Frigidaire Affinity dryer?

How do you find the error code on affinity dryer?

How to Retrieve the Error Codes in a Frigidaire Affinity Front Load Dryer

  1. Press and release any button on the dryer’s display panel to awaken it from idle mode.
  2. Wait for 5 to 10 seconds then push and hold “Start/Pause” and “Cancel” at the same time.
  3. Watch for the indicator lights on the control panel to flash.

How do I fix my e64?

One such error code is e64. The e64 error code means that your dryer’s heating element is faulty and needs to be fixed….

  1. Step 1 – Disassemble the dryer.
  2. Step 2 – Check the heating element.
  3. Step 3 – Check the thermal fuse.
  4. Step 4 – Check the cycling thermostat.