Questions

How do I log into APC UPS?

Connect to the UPS/device serial port using the correct APC configuration cable….9600 bps, 8 data bits, no parity, 1 stop bit, and no flow control.

  1. Apply the port settings to establish the connection.
  2. Press enter 3-5 times to display the username prompt.
  3. Use the default username and password of “apc”.

What is the default IP address of APC UPS?

192.168.2.66
The default IP address is 192.168. 2.66 with a subnet mask of 255.255. 255.0. The default username is admin and the default password is admin01.

How do I reset my APC password?

Press the Reset button a second time immediately while the LED is rapidly flashing – which will cause the LED to then go off – in order to reset the User Name and Password to their defaults temporarily (the default User Name and password are both apc).

How do I reset my APC UPS?

APC Smart UPS – How to reset / restart

  1. Turn off and unplug UPS from wall.
  2. Press and hold the OFF button again.
  3. You may see a quick flash of the LED’s and you should hear an audible “”click”” from the UPS.
  4. Turn UPS back on.

How do I assign an IP address to an APC PDU?

APC PDU configuration trick

  1. Use ARP to define an IP address for the PDU, and use the PDU’s MAC address in the ARP. command.
  2. Use Ping with a size of 113 bytes to assign the. IP address defined by the ARP command. For.
  3. Use Telnet to access the PDU at its newly. assigned IP address.
  4. Use apc for both user name and password.

How do I change the IP address on APC UPS?

On the Web interface, access the Configuration menu and select the following option:

  1. • Configuration > Network > TCP/IP > IPV4 Settings.
  2. Configure the desired static IP address an click on the Apply button.

How do I restart APC UPS?

Solution: To reset the network interface of a SMT, SMTL, or SMX model UPS, on the display interface hold the UP and DOWN buttons simultaneously for 5 seconds. The display flashes to indicate that the network interface has restarted.

How do I factory reset my APC PDU?

Resetting APC AP7920 PDU

  1. Press and hold the reset button for about 10 seconds.
  2. The status light should blink rapidly.
  3. Release the reset button then press it again for about a second.
  4. The light should go orange.
  5. After about 20 seconds the reset will complete and the device will have booted.