New

Is the Brother HL-2240 printer wireless?

Note that the HL-2240 doesn’t offer duplex printing, so, if you want to print on both sides of a piece of paper, you have to manually turn the sheet over and place it back in the paper tray. This model also lacks both Ethernet and Wi-Fi support, so it can only be connected to your computer via USB.

Is Brother HL 2140 wireless?

Is this a wireless printer? Answer: No. The HL-2140 has only a USB interface and may not be a current model now.

How do I connect my Brother HL-2240 to my computer?

Insert Brother HL-2240 CD disk into the CD/DVD drive on your computer, and run the setup wizard of CD, and follow their instructions to install it. Now connect the Brother HL-2240 printer USB cable to computer, when installer wizard asks (Note: Do not plug before asking). Wizard will analyzing when you connect it.

Is a Brother HL 2230 wireless?

Wireless Printing, Duplex Two-Sided Printing.

How do I make my Brother HL 2270dw wireless?

Configure the wireless settings:

  1. Place the Brother machine within range of your WPS or AOSS™ access point/router.
  2. Make sure that the power cord is plugged in.
  3. Turn on the machine and wait until the machine is in the Ready state.
  4. Hold down the WPS or AOSS™ button on your WLAN access point/router for a few seconds.

How do you reset the drum on a Brother printer HL 2140?

Brother HL-2140 – Reset Drum Simply open the front cover, and hold the “GO” button until all four LED’s are lit. Release the “GO” button and close the front cover.

How do you reset the toner on a Brother HL 2230?

Brother HL-2230 Toner/Drum Reset Print Ensure the printer is turned off. Open the printer front cover. Hold the Go button while turning the printer on. When the Toner, Drum, and Error LEDs are on and the Ready LED is off, release the GO button.

How do I connect my Brother printer wirelessly?

To set up your Brother machine on a wireless network:

  1. Connect the power cord to your Brother machine and then connect it to an electrical socket.
  2. Press Menu button on the machine’s control panel.
  3. Press the Up or Down arrow key to select Network and press OK.
  4. Press the Up or Down arrow key to select WLAN and press OK.