Mixed

How do you change the font size on a Brother P Touch 1000?

How do I change the font size?

  1. Press the FONT key.
  2. Press the UP OR DOWN ARROW key to highlight the current size selection.
  3. Press the LEFT OR RIGHT ARROW key to change the current size selection.
  4. Press the OK key to confirm the change.

How do I reset my P-touch 1000?

How do I reset the P-touch back to its default factory settings?

  1. Turn off the P-touch.
  2. While holding down and , press to turn the P-touch back on.
  3. Finally release and .
  4. “1. ENG? ” is displayed. The machine has been initialised.

How do I set up my Brother P Touch?

Setting up the P-touch labeler

  1. Open the cassette cover.
  2. Insert the tape cassette.
  3. Close the cassette cover. If you cannot close the cassette cover, check to ensure the white lever is in the up position. If not, lift the lever, and then attach the cover. Make sure that there is no slack in the tape.

How do you use a P-touch label maker?

[1] It’s as easy as:

  1. highlight the text you want inserted into your label.
  2. click the text you want inserted into your label (click on the button with the letter “P” on the toolbar to pull highlighted information into the label creation software)
  3. print the text you want inserted into your label.

How do I change the label length on my Brother P-Touch?

FAQs & Troubleshooting

  1. Press the [Label] key ( / ).
  2. Press the [Cursor] key ( ) until [Label Length] is displayed.
  3. Press the [OK] key ( ).
  4. Press the [Cursor] key ( ) until your desired length is displayed. ( AUTO or 30 – 300 mm / 1.2″ – 12.0″)
  5. Press the [OK] key ( ) to apply the setting.

How do I shorten the P-Touch label maker?

How do I eliminate the margin from the start or end of my label when printing?

  1. Press the [Label] key ( / ).
  2. Press the arrow key or. to select “Margin”.
  3. Press the arrow key or. to select “Narrow”.
  4. Press the [OK] key ( ) or [Enter] key ( / ). This eliminates the margin at the end of the tape after printing as shown below:

How do I connect my Brother P-Touch to WIFI?

b Press and hold the Wireless Mode button on the P-touch labeler for more than 5 seconds. After the Wi-Fi lamp starts flashing in 0.5 second intervals, release the button. c Press the WPS button on your WLAN access point/router. d When the connection is established, the Wi-Fi lamp is lit.

How do I connect my Brother P-Touch to my phone?

For Android™ OS 4.4 or earlier (Not available for Design&Print 2): Turn the Bluetooth setting on, and then select the printer.

  1. To confirm the Android™ version, see Settings –> Device information –> Android™ version.
  2. The printer to connect to is PT-[model name][the last four digits of the printer’s serial number].