What is drilling operation in lathe machine?

Drilling is the operation of producing a cylindrical hole in a workpiece. It is done by a rotating tool, the rotating side of the cutter, known as a drilling drill. In this operation, The workpiece is revolving in a chuck or a faceplate and the drill is held in the tailstock drill holder or drill chuck.

What is the drilling machine process?

Drilling is a cutting process that uses a drill bit to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute.

What is drilling operation?

Drilling operation is the first contact between the formation and the nonnative fluids and equipment. Drilling fluids play a vital role during the drilling operations by lubricating the bottom-hole assembly, cooling the drilling bit, lifting-up the cuttings, and forming impermeable filter cakes.

What is the function of drilling machine?

drill press, also called Drilling Machine, device for producing holes in hard substances. The drill is held in a rotating spindle and is fed into the workpiece, which is usually clamped in a vise resting on a table.

Which operation is performed after drilling?

After the drilling operation is complete, the drill is removed from the hole and the power is turned off. The boring operation is that where enlarging a hole by means of adjustable cutting tools with only one cutting edge is accomplished. A boring tool is employed for this purpose.

What is lathe machine parts?

The main parts of the lathe are:

  • Headstock: The headstock is usually located on the left side of the lathe and is equipped with gears, spindles, chucks, gear speed control levers, and feed controllers.
  • Tailstock:
  • Bed:
  • Carriage:
  • Lead Screw:
  • Feed Rod:
  • Chip Pan:
  • Hand Wheel:

Can we perform drilling on a lathe machine?

The tailstock of a lathe can be used for drilling, with the aid of a drill chuck attachment. The drill chuck has a morse taper shaft which can be push into the shaft of the tailstock, locking it in position.

What is a drilling operation?

What are types of drilling machine?

Types of Drilling Machines

  • Portable drilling machine.
  • Bench drilling machine.
  • Pillar drilling machine.
  • Radial drilling machine.
  • Gang drilling machine.
  • Multi-spindle drilling machine.
  • Deep hole drilling machine.

How to operate a lathe machine?

To perform different lathe machine operations on a lathe, the workpiece may be supported and driven by any one of the following methods: Workpiece held between centres and tool driven by carriers and catch plates. Workpiece held on a mandrel which is supported between centres and driven by carriers and catch plates.

What is the difference between lathe and drilling machine?

I have listed 10 points on the differences between Lathe and Drilling Machine: 1. Lathe Machine is called as the “ mother of all Machine ”. Lathe Machine performs more operations than the drilling machine. Drilling Machines can perform less operation as compared to the Drilling machine.

How do you use a center drill on a lathe?

Center Drilling Turn on the lathe and set the speed to around 600 RPM. Use the tailstock crank to advance the drill slowly into the end of the workpiece and continue until the conical section of the center drill is about 3/4ths of the way into the workpiece.

What is a drilling machine?

A drilling machine is also a production machine but we use these machines for holes in the workpiece with the use of drill bit tools. Here you can read Drilling Machine in detailed.